The Garmin Zümo 220 GPS is sold with a RAM mount that can be mounted on different types of motorbike handle bars. In the case of the Norge the RAM mount wil fit the mount of the hydraulic fluid reservoir.
The handlebar on the left with hydraulic fluid reservoir mount. The RAM mount has just enough space to fit alongside the button with the white arrow to raise the windshield.
The 2 screws that hold the reservoir (and the cluch lever and rearview mirror) are hex socket keys fo 5 mm.
Clockwise: plastic bag with U-shaped holder that cannot not be used on the Norge handlebar. 2 spacers, 2 bolts, 2 washers, 2 shorter bolts with different threading. Hex key socket bits of 4 and 5 mm. Socket wrench.
Step 1 – Remove the original bottom screw. Leave the top screw fixed.
Step 2 – Use this screw to hold against the RAM mount screws.
Match the RAM screws tind if the threading fits with the original screw, by holding them together. In this case it is the screw with the finer thread.
Step 3 – Put the RAM screw through the washer, RAM mount and spacer. Compare the length of the what comes out of the screw to the length of the original screw. The spacer needs to be shortened a little bit. It is made of plastic and can be cut with a cutter knife.
Attention: the screw in the picture above is passed through the top hole of the RAM mount, in the next step the screw needs to go through the bottom hole.
Step 4 - fix the bottom of the RAM mount sideways and tighten it a little to keep the hydraulic fluid reservoir in place, before removing the original top screw.
Step 5 – Remove the top screw.
Step 6 – Move the RAM mount vertically and insert the screw with washer and spacer. Fix the screw
Step 7 – Thighten both screws and the job is done.
The install looks great! Do you have any images with the GPS mounted?
ReplyDeleteCheers